— 55 —
E001
E003
E004
E005
E008
E009
E010
E011
E015
E016
E017
E018
E019
E021
E023
E024
E025
E026
E029
E030
E031
E032
E033
E035
E036
E037
Return the mode switch to its original setting
and finalize the operation.
Press the original clerk button and finalize
the transaction before pressing another clerk
button.
Input correct check number or assign the
proper clerk number.
Complete operation.
Reallocate memory or expand memory (if
possible).
Enter a clerk number.
Enter password.
Close the drawer.
Shut the cash drawer.
Switch to another mode and then back to the
RF mode for the next transaction.
Input a check number.
Input a table number.
Enter the number of customer.
Correct the program.
Perform stock maintenance.
Perform stock maintenance.
Retry registration/register to a proper
department or PLU.
Register condiment/preparation PLU.
Finalize the transaction.
Register <RATE TAX>.
Press <SUBTOTAL>.
Press <FS/ST>.
Enter the amount tendered.
Input amount tendered again.
Perform pick up operation.
Enter correct amount.
Mode switch position changed before
finalization.
Clerk button pressed before finalization of
a registration being performed under
another clerk button.
The signed on clerk differs from the clerk
performed the tracking check registration.
Initialization or unit lock clear operation in
progress.
Memory allocation exceeds total memory
capacity.
Registration without entering a clerk
number.
Operation without entering the password.
The drawer is left open longer than the
program time (drawer open alarm).
Attempt to register while the cash drawer
is open.
Printer error
Two consecutive transactions attempted
in the refund mode.
Attempt made to register an item without
inputting a check number.
Attempt made to register an item without
inputting a table number.
Finalize operation attempted without
entering the number of customer.
No department linked PLU is registered.
Actual stock quantity becomes less than
the minimum stock quantity.
Actual stock quantity becomes/is negative.
Scale read error/perform non-scale
registration to scalable item.
No condiment/preparation PLU is
registered.
Item registration is prohibited, while partial
tender.
Finalization of a transaction attempted
without registering rate-tax.
Finalization of a transaction attempted
without confirming the subtotal.
Finalization of a transaction attempted
without confirming of the food stamp
subtotal.
Finalize operation attempted without
entering amount tender.
Change amount exceeds preset limit.
Contents of the drawer exceed
programmed limit.
High amount lock out/low digit lock out
error
10. ERROR CODE LIST
Wrong mode
Wrong operator
Error INIT/FC
Insufficient
memory
Please sign on
Enter password
Close the drawer
Close the drawer
Check R/J
printer
Change back to
REG mode
Enter CHK/TBL
number
Enter Table
number
Enter number of
customers
No Dept Link
Stock shortage
No stock
Illegal scale
read or entry
Enter condiment/
preparation PLU
In the tender
operation
Press RATE TAX
key
Press ST key
Press FSST key
Enter tendered
amount
Change amount
exceeds limit
Remove money
from the drawer
Digit or amount
limitation over
ActionMeaning
Prompt message
To Next Page
Loading...
Need help?
General
