— 7 —
Flag clear operation
1. Plug the power cord into an AC outlet.
2. Set the mode switch to OFF position.
3. While holding down
, set the mode switch to PGM.
4. Release
.
You should see “FFFFFFFFFF” on the display.
If 10 Fs are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Press
to complete.
Note: After flag clear, clerk 1 is assigned automatically. So do not program clerk 1 as not assignable or
not operable in PGM mode.
Init 2 operation
1. Plug the power cord into an AC outlet.
2. Set the mode switch to OFF position.
3. While holding down
, set the mode switch to PGM.
4. Release .
You should see “FFFFFFFFFF” on the display.
If 10 Fs are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Enter “8888888888” and press
to complete.
After completion of flag clear, receipt is issued.
After completion, receipt is issued.
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
T
JOURNAL
FEED
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
RECEIPT JOURNAL
FEED FEED
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
T
JOURNAL
FEED
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
To Next Page
Loading...
Need help?
General
