Casio VA-10 - Page 14

Operations
oper
“The following describes the parameters that can be adjusted for the flanger and chorus effects
using EFFECT CONTROL.
PARAMETER I = Rate
Use this parameter to control the speed of the periodic delay before the second sounding of
note, Pressing /\ shortens the delay, while 7 lengthens it,
PARAMETER 2 = Amount
Use this parameter to control the amount of periodic delay applied. Pressing (\ increase the
‘amount, while \/ decreases it,
* Distortion (Effect 13)
No. | Effect Name Description Double Ettects*
Distorts the orginal note ard then mixes | 20,21, 46,47, 55
13 | DISTORTION | tho distorted version with the oral
© ‘These are the double effects that include the single effect being described.
‘The following describes the parameters that can be adjusted for the distortion effect using
EFFECT CONTROL.
PARAMETER 1 = Mix Ratio
Usethis parameter tocontrol the ratio between the original sound and itdistorted versionbeing
xed together, Pressing /\ decreases the distorted sound ratio. Note thatthe distorted sound
ratio is at its maximum at the default
PARAMETER 2 = No change
+ ‘Tremolo (Effect 14)
No. | Effect Name Description Double Etfects”
‘Signty rages andiowers he volume ot | 29,35, 96,53,
4. | TBEMAS: the notes tocreatea temo ete.
* ‘These are the double effects that include the single effect being described.
Operations
‘The following describes the parameters that can be adjusted for the tremolo effect using
EFFECT CONTROL.
PARAMETER 1 = Rate
Use this parameter to control the speed of the change in volume, Presi
speed, while (/ decreases it
1) inereases the
PARAMETER 2= Amplitude
Use this parameter to control the amplitude, which extends from the point where the sound
reaches its maximum volume to the point where the minimum volume is reached, Pressing
{\ increases the amplitude, while () decreases it,
* Vibrato (Effect 15 and 16)
No. | Effect Name Description Double Etfects*
‘Sight raises and lowers the pitch the | 26, 27, 28, 29
15 | VIBRATO =
HeAw Bedale ad owan ta pict | 40, 4,52
ih | Neewras eee erg beta
* These are the double effects that include the single effect being described.
‘The following describes the parameters that can be adjusted for the vibrato effect using
EFFECT CONTROL.
PARAMETER 1 = Amplitude
Use this parameter to control the amplitude, which extends from the point where the sound
reaches its maximum pitch to the point where the minimum pitch is reached. Pressing /\
increases the amplitude, while \y decreases it
PARAMETER 2= Rate
Use this parameter to control the speed of the change in pitch. Pressing /\ increasesthe speed,
while \/ decreases it.
7