Casio VZ-10M - Page 14

E2
state, the internal line of LINE A is set to MIX, while LINE B
PHASE - i.e. M3 becomes the phase of M4. (@)
‘this state, EXTERNAL PHASE from LINE A is specified, the
‘changes to that shown on the right, and the resulting waveform
‘output through LINE B. Once again, LINE A does not sound,
only as the phase of LINE B. (®)
this abit clearer, think of how a guitar player uses preamp stages
distortion, With only one volume control, the guitarist must
LOUD to overdrive his amp and get a warm, distorted sound.
If he adds a preamp or has a master volume control, he can
hhis amp and still maintain a reasonable volume level. (1)
‘more amplifiers, the guitarist could theoretically create an in-
‘buzz”, as the distortion can be compounded with each
rol. (@)
‘modules
work
much
inthe
same
way
-
with
only
one
oscil
«can
produce
only
one
sound.
But
with
8 independent
oscilla
«an
create
patches
with
varying
degrees
of complexity
- using
together
to
create
a
“fat”
layered
patch
consisting
of
sounds
‘modulators,
oF to create
an individual
sound
output
{rom
a
with
a chain”
of modulation
stretching
from
MB all the
10 M1.
In essence,
the
modules
used
to create
modulation
are
{" the output
modules.
(®)