86
Eco Mode: Enter Eco Mode. PMD RW 0: Off (Bright), 1: Off (Normal),
2: On (Auto), 3: On (Manual 1),
4: On (Manual 2),
5: On (Manual 3),
6: On (Manual 4),
7: On (Manual 5)
Freeze: Switches freeze on or off. FRZ RW 0: Off, 1: On
Keystone Correction:
Specifies the keystone correction setting as a value that
corresponds to the typical Setup Menu “Keystone
Correction” settings below.
0: Keystone Correction –60
60: Keystone Correction 0
120: Keystone Correction +60
Example: 65 here, specifies a setting equivalent to
Keystone Correction +5.
KST RW 0 to 120
Keystone Correction +/–:
Raises or lowers the current keystone correction setting
by 1.
+: KSP
–: KSM
W 0 to 120
Key: Operation executed when a key is pressed.
Setting values 31 through 34 are supported by XJ-A
Series projectors only.
KEY W 1: S, 2: T, 3: W, 4: X,
5: ENTER, 6: ESC, 10: FUNC,
11: MENU, 12: POWER,
13: AUTO, 14: INPUT,
15: TIMER, 16: ASPECT,
17: BLANK, 18: FREEZE,
19: ECO, 20: KEYSTONE +,
21: KEYSTONE –,
22: D-ZOOM +,
23: D-ZOOM –,
24: VOLUME +,
25: VOLUME –,
26: PLAY( ),
27: REWIND( ),
28: FORWARD( ),
29: PREVIOUS( ),
30: NEXT( ), 31: ZOOM +,
32: ZOOM –, 33: FOCUS S,
34: FOCUS T
Setup Type: Specifies how the projector is set up relative to
screen for projection.
0: Projection to a screen in front of the
projector*
1
1: Ceiling mounted projection from behind the
screen*
2
2: Projection from behind the screen*
1
3: Ceiling mounted projection to a screen in
front of the projector*
2
POS RW 0 to 3
APO: Used to change the Auto Power Off setting (trigger time
setting or Auto Power Off disable).
APO RW 0: Off, 1: 5 minutes,
2: 10 minutes, 3: 15 minutes,
4: 20 minutes, 5: 30 minutes
Error: Reads the projector error status. STS R 0: Normal, 1: Fan error,
2: Temperature error,
7: Light error, 16: Other error
Function
Command
Name
RW Setting Range
To Next Page
Loading...
