Caution
• The Projector can be configured to enable or disable power via wired LAN on from the
standby state. To do so, use [Wired LAN Settings]-[Remote On] on the Projector's Setup
Menu.
Enable
EnableEnable
Enable : Power on enabled.
Disable
DisableDisable
Disable : Power on disabled. (Default)
Initializing network settings or performing a "Restore All Defaults" operation with the Setup
Menu will cause this setting to change to "Disable". If you are operating the Projector using a
wired LAN setting, be sure to change this setting back to "Enable" after initialization.
• Up to firmware version *.0.3.2, when the IP address is set manually using the System Admin
screen, the default gateway setting is configured by the Projector, regardless of the input
value. When performing connection from an external network, allow acquisition of the IP
address and default gateway address under a DHCP environment.
From firmware version *.0.3.3 onwards, the default gateway setting is configured in
accordance with the input setting.
Checking the Current Firmware Version
Perform the following procedure to check a Projector's current firmware version.
1. Turn on the Projector and plug USB memory into the USB port. Memory contents do not matter.
2. Under initial Projector default settings, Viewer should start up automatically, unless plug and
play has been disabled on your Projector. If Viewer does not start up, press the INPUT key to
switch input to USB.
3. When the main Viewer window is projected, press the Projector's [▲] and [
◄
] cursor keys at the
same time.
4. This will cause the Projector's current firmware version number to appear in the lower left
corner of the screen.
To Next Page
Loading...
Need help?
General
