E-2
XJ-SK600 Overview
The XJ-SK600 Projector System uses a Control Box to sync two projectors so their output looks and
acts as if it is coming from a single projector. A powerful collection of projected image shaping functions,
enables clear image projection not only onto a flat screen, but also onto curved and irregular surfaces.
Important!
Important!
z After the Projector System has been installed and adjusted, do not alter the cabinet position or
positions of the projectors inside the cabinet, the projector zoom ring settings, or the screen
position.
Any changes to the above will require re-adjustment of the Projector System.
z When installing the Projector System or when adjusting the cabinet, take care to avoid getting
your hands pinched under the cabinet or by door in the back of the cabinet.
Before getting into setup of the Projector System, take a few moments to make sure that all of the items
listed below are included.
z XJ-SK600 Setup Guide (This manual)
z Cabinet*
1
z Feet ×4 (for placement on a flat surface)
z Control Box (YA-S10)*
1
z Projectors (XJ-M250) ×2*
1
z Control Box remote controller (YT-200)
z Control Box AC adapter and power cord
z Projector remote controller (YT-120)
z Projector power cords ×2
z Remote controller batteries (AAA-size, test use) ×4
z HDMI cables ×2
z RS-232C cables ×2
z Mini D-Sub Cable
z DATA PROJECTOR CD-ROM (Contains projector User’s Guide)*
2
z DATA PROJECTOR Setup Guide
z DATA PROJECTOR “Read this first” Sheet
z Warranty Certificate
Unpacking
*1 The Control Box and two projectors are installed in the cabinet at the factory.
*2 Some XJ-SK600 models do not come with a CD-ROM. If your projector does not come with a
CD-ROM, download the User’s Guide from the CASIO projector website. See “User
Documentation” (page E-1) for more information.
To Next Page
Loading...
Need help?
General
