9
1. Open doors and windows to ventilate room.
2. Let the fire out, or eject and safely dispose of fuel from the stove.
3. Check for flue chimney blockage and clean if required.
4. Do not attempt to re-light the fire until the cause has been identified and
corrected.
If necessary, seek professional advise.
6. Operating Instructions
The controls
The amount of heat emitted by the stove is
regulated using the air control build under the
stove.
Opening the primary air control vent can be
used to revitalize the fire effectively, producing
significantly more vigorous combustion.
The “glass wash” feature when used, should
function to effectively keep the inside of the
door glass clear of smokey deposits.
The temperature reached by these items during operation may cause an
injury to an end-user. As these are intended to be adjusted during
operation, it is recommended that protective gloves are wore when handing
these parts.
Fuel
This stove will function with wood fuel, but in general all fuel should be dry and timber
should be well seasoned so as to have a moisture content below 20%. The use of
damp wood will result in more soot and tar deposits being left in the chimey, flue and
stove, and will not release heat if thermal energy is being used to drive out moisture
from the fuel.
DO NOT BURN wet or unseasoned wood, construction timber, painted or treated
wood, driftwood or manufactured board products. Doing so will result in the wood
To Next Page
Loading...
