14
A forgotten dish can be added at any time before the detergent cup opens.
Open the door a little to stop the wash cycle.
After the spray arms stop working, you can open the door
completely.
Loa d the forgotten dishes.
Close the door, the dishwasher will start running again
after 10 seconds.
4
3
2
1
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling for service.
NOTE:
It is dangerous to open the door when washing,because the hot water may scald you. Take extra care to avoid this.
When the working cycle has finished, the buzzer of the dishwasher will soundfor 8 seconds, then stop. Turn off
the appliance using the ON/OFF button and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher toavoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Turning on the Appliance
Premise: A cycle that is underway can only be modified if it
has only been running for a short time. Otherwise, the detergent
may already have been released, and the appliance may have
already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
To cancel a cycle, open the dishwasher door then press and hold the
'prog.' button for more than 3 seconds. The cycle is then cancelled
and a new cycle can be selected.
NOTE: If you open the door when washing, the machine
will pause. When you close the door, the machine will
re-start after 10 seconds.
The program lights show the state of the dishwasher:
a) All program lights off --> stand by
b) One of the program lights on --> pause
c) One of the program lights blinking --> run
Prog.
Prog.
Starting a wash cycle...
1 Pull out the lower and upper basket, load the dishes and
push them back. It is recommended that the lower basket is
loaded first, then the upper one
(see the section entitled " Loading the Dishwasher " ).
2 Pour in the detergent(see the section entitled "Salt,
Detergent and Rinse Aid").
3 Insert the plug into the socket. The power supply is 220-240
V AC 50 HZ, the specification of the socket is 12 A 250V AC.
Make sure that the water supply is turned on to full pressure.
Pre
ss the "prog. " button to select a desired "Wash cycle". (See
the section entitled "Wash Cycle Table" )
5 Ensure the door is properly closed.
NOTE: A click could be heard when the door is closed perfectly.
6 When the washing is over, you can shut off the switch by
pressing ON/OFF button.
4 Open the door, press the ON/OFF button, and the ON/OFF light will turn on.
To Next Page
Loading...
