23
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
intothesink.Itwillbenecessarytodrainexcesswaterfromhosesintoabowl or suitable
containerthat is held outside and lower than the sink.
Water Outlet
The following things should be checked before starting the dishwasher.
Syphon Connection
After installation, please keep this manual for future reference.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is no water leaking from any of the hose connections
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are secure
7 All packing materials and the dishwasherhave been removed from the inside of
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time,letthe
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the waterinletbecoming blocked and damaging the appliance.
The water supply to the appliance can also be connected to the household hot water
line (such as, central system, heating system),as long as it does not exceeda
temperature of 60 C. In this case, the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as
described in the section for the connection to the cold water line.
Position the appliance in thedesired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equippedwith water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
The waste connection must be at a height of between 40 cm (minimum) and100 cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a hose clip. The free end of
the hose must not be immersed in water.
For models not fitted with a safety inlet hose, in order to prevent continual water pressure in the inlet hose, please turn
off the water supply after each use.
To Next Page
Loading...
