Cata GHFF60SS2 - Page 11

11
In more detail...
GB IE
Operation
Operation
On the control panel (g. 4) to the right every knob there is a diagram to
indicate the burner to which the knob in question refers. The burners can
be switched on in several ways, according to the type of appliance and its
individual features.
> Manual “ON” switch (this is always possible even if the electric current is
off):
• Turn the knob (g. 5) corresponding to the selected
burner in a counter-clockwise direction so that the
knob is at MAXIMUM (this corresponds to a large
ame).
• Use a piezo electric spark gas ignitor.
> Automatic electric “ON” switch for burners with safety device
(thermocouples):
• Turn the knob (g. 5) corresponding to the selected burner in a
counter-clockwise direction so that the knob is at MAXIMUM.
• Once the burner is lit, keep the knob pressed in for about 10 seconds
in order to allow the ame to heat up the thermocouple. If the burner
goes out when the knob is let go, repeat the operation.
Caution
• If there is no electric current you can light the burners with
piezo electric spark gas ignitor.
• The burners can only be lit with safety thermocouples when
the knob is on MAXIMUM.
g. 5
Use of the burners