Using your Hob
To start cooking
• After power on, the buzzer beeps once, all the indicators light up for 1 second then
go out, indicating that the hob has entered the state of standby mode.
1. Touch the ON/OFF switch. all the indicators show “– “
2. Place a suitable pan on the cooking zone that you
wish to use.Make sure the bottom of the pan and the
surface of the cooking zone is clean and dry.
3. Touching the heating zone selection control, and an
indicator next to the key will flash
4. Select a heat setting by touching the “-”、 “+” Or touching the “slider” control.
• If you don’t choose a heat setting within 1 minute, the Induction hob will
automatically switch off. You will need to start again at step 1.
• You can modify the heat setting at any time during cooking.
When you have finished cooking
1. Touching the heating zone selection that you wish to
switch off
2. Turn the cooking zone off by scrolling down to”0” or Or touching the “slider”.
Make sure the display shows”0”.
3. Turn the whole cooktop off by touching the ON/OFF
control.
4. Beware of hot surfaces
“H” will show which means cooking zone is too hot to touch. It will disappear
To Next Page
Loading...
