Table of figures
Figure 1: Dashboard layout for models with standard instruments 7
Figure 2: Dashboard layout for CSR with Integral dash 10
Figure 3: Dashboard layout for Seven 485/ Superlight R400 (Reverse for RHD) 11
Figure 4: Dashboard Layout for Seven 620 R 12
Figure 5: 4-point and 6-point harness 14
Figure 6: Tensioning the hood 14
Figure 7: Hood folding procedure 15
Figure 8: 5/6 speed and sequential gearbox 18
Figure 9: Under bonnet location – EU5 K6A 27
Figure 10: Under bonnet location – EU4 Sigma 120 28
Figure 11: Under bonnet location - Sigma 125 / 140 29
Figure 12: Under bonnet location – Duratec 175 30
Figure 13: Under bonnet location – Duratec 180 / 210 31
Figure 14: Under bonnet location - Duratec 237 32
Figure 15: Under bonnet location – Duratec 310 33
Figure 16: Front axle stand positioning 34
Figure 17: Rear axle stand position 34
Figure 18: Wet sump dipstick level indicator 35
Figure 19: Dry sump tank cap and level indicator for CSR 200 / 260 only 35
Figure 20: Coolant expansion bottle 36
Figure 21: Clutch fluid reservoir 37
Figure 22: Brake fluid reservoir 37
Figure 23: Battery and clamp 38
Figure 24: Front and rear jack points 40
Figure 25: Jump lead connection 44
Figure 26: Fuse box and relay location 45
Figure 27: K6A Fuse box and relay layout 45
Figure 28: Duratec Fuse Box and Relay layout 46
To Next Page
Loading...
Need help?
General
