Cattani MICRO SMART - System Parameters Setup - Delays, Options, Network; Delay Times and Running Options; Network and Zig-Bee Settings

ENGLISH
Blower Off Delay Time (max. setting: 300”)
Running Options
This enables or disables the amalgam level sensor.
Set to 0: without amalgam separator
Set to 2: with amalgam separator
Drive Commands
Factory use only.
Modbus address
This menu is not currently used.
Network address
Specify the network address of the Micro SMART for Zig-
Bee visualization.
Zig-Bee Minimum Channel
Select the minimum channel on which the Micro SMART
shall communicate.
Zig-Bee Maximum Channel
Select the maximum channel on which the Micro SMART
shall communicate.
41