7. If too much solution has entered the
dispensing chamber, it can be poured
back into the main bottle by tipping
the bottle towards the small tube on
the side.
8. Unscrew and remove the red cap.
Pour the solution from the dispensing
cup into the full Pulse Cleaner.
Take care to not allow more solution
from the main bottle ow into the
dispensing cup.
9. With a disposable cloth, wipe any
drips of solution from the bottle
(andthen dispose of the cloth).
10. Connect suction hoses to Pulse
Cleaner – adaptors may be required as
hose sizes vary. Pulsed aspiration of
the solution will happen automatically.
Puli-Jet Gentle leaves a residue on the inside of pipes and suction tubes in order to stop
growths on these surfaces. This is the reason that you may sometimes nd the surface
of a tube to be ‘oily’. This is completely normal and the product is designed to do this.
Puli-Jet Gentle should never be pre or semi diluted. It must be diluted (according to the
instruction) and then used straight away.
11. Once pulsing has stopped please
remove hoses from the Pulse Cleaner.
Please note a small amount of
solution will remain inthe bottom of
the cleaner. This can be poured down
the spittoon or aspirated manually.
12. It is highly recommended to continue
aspirating air for several minutes
before shutting down the suction
system. This ensures that the
disinfectant reaches the suction
unitinthe plant room.
To Next Page
