What to do if the LED is off on my Cattron Control Systems?
If the LED on your Cattron Control Systems is off, there could be several reasons. First, ensure the transmitter is turned on by pressing the ON/ALARM button. If that doesn't work, the batteries might be dead, so try replacing them. If the LED remains off after these steps, it could indicate a transmitter failure, and you should call for service.
What to do if the LED is continuously on for Cattron Control Systems?
If the LED on your Cattron Control Systems is continuously on, with a slight flicker, it might be because a switch was activated during startup. Try restarting the transmitter without pressing any other switches. If the problem persists, it could indicate a transmitter failure, and you should call for service.
Why is the LED cycling on and off (0.5 s on, 0.5 s off) on my Cattron Control Systems?
If the LED on your Cattron Control Systems is cycling on and off (0.5 seconds on, 0.5 seconds off), it likely indicates that the batteries are low. Change the batteries at the next convenient opportunity.
What to do if the LED flashes red/green on my Cattron Control Systems ('A' series only)?
If the LED on your Cattron Control Systems ('A' series only) is flashing red and green, it indicates that the batteries are low. You should change the batteries at your earliest convenience.
General| Brand | Cattron |
|---|---|
| Model | CommandPro 23 Series |
| Category | Control Systems |
| Language | English |
To Next Page
