gloss TALL DRESSER
Made in Vietnam - r05 Page 2 of 4
1
2
Insert 4 wood dowels into middle panel as
shown. Fit dowels of middle panel into
corresponding holes of left and right side panels.
Secure each side panel with 2 bolts, 2 spring
washers and 2 flat washers. Secure, but do not
over tighten, bolts with a phillips head
screwdriver.
3
4
Insert 4 wood dowels into bottom panel as
shown. Fit dowels of bottom panel into
corresponding holes of side panels, and secure
with 4 bolts, 4 spring washers and 4 flat
washers.
With assistance of another adult, position unit
upright. Fit back panel into corresponding
grooves of side panels as shown.
NOTE: Do not
over tighten bolts
left side
panel
bottom
panel
back panel
NOTE: Make sure grooves
of left and right side panels
are facing each other during
assembly as shown
right side
panel
A. Insert 2 wood dowels into left and right side
panels as shown.
B. Fit dowels of side panels into corresponding
holes of top panel. Secure each side panel with
2 bolts, 2 spring washers and 2 flat washers.
A
B
top panel
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
To Next Page
Loading...
