10
Procedure: #*0000 890 NN X #
NN= the last 2 digits of the original Extension
X= 0 - To Disallow
1 - To Allow
Default: Extensions are disallowed
. Conference with 1 Junction & 1 Ext .
An extension user can establish a conference with an extension and a Junction line.
Process: During conversation with a Junction line, Hook-Flash from SLT or HOLD Key from KTS to hold the line.
Then dial Ext No from SLT/KTS
Or Press CONF key and dial Ext No. from KTS
. Conference with 2 Junctions .
An extension user can establish a conference with 2 Junction Lines:
Process: During conversation with a Junction line - Hook-Flash from SLT or HOLD Key from KTS - ## (To park the
Call) – 0 – Tel No (who is to
be included in conferencing) – Hook Flash - # - Now all 3 party can talk to each other.
When Ext keeps the Handset down, the conference ends.
. Date and Time setting .
To set Date and Time-
Dial- #*0000 + 28 YY MM DD A/P HH MN D #
Where YY- year
MM- Month (01-12)
DD- Date (01-31)
HH- Hour (01-12)
MN- Minute (00-59)
A/P- 0 for AM, 1 for PM.
D- Day (1for Sun, 2 for Mon, …. 7 for Sat)
. Day / Night Mode .
The PBX can be configured in 2 sets of programming. One for the day mode and one for the night mode.
To change the system to Day Mode, Dial # 20
To change the system to Night Mode, Dial # 21
Default: Day Mode.
Note: The command can be given from the programming extensions only i.e., 601, 602, 603 and 604.
. Denied Table – A .
Numbers to be disallowed to extensions whose L = 4, are to be defined in this table. For value of L refer “Junction Dialing
Controls”.
This table has 16 Locations.
Procedure: Dial #0000 + 41 QQ ABCD#
Where QQ= 01 to 16 (16 Locations of the Table)
ABCD= The starting 4 digits of the Tel numbers to be denied to extension.
For less than 4 digits, dial # at the end of digits.
To clear this Table: Dial #0000 + 41 #
To clear a particular location of this table: Dial #0000 + 41 QQ #
. Denied Table – B .
Numbers to be disallowed to extensions whose L = 5, are to be defined in this table. For value of L refer “Junction Dialing
Controls”.
This table has 16 Locations.
Procedure: Dial #0000 + 42 QQ ABCD#
Where QQ= 01 to 16 (16 Locations of the Table)
ABCD= The starting 4 digits of the Tel numbers to be denied to extension.
For less than 4 digits, dial # at the end of digits.
To clear this Table: Dial #0000 + 42 #
To clear a particular location of this table: Dial #0000 + 42 QQ #
. Do Not Disturb (DND) .
In DND mode, no one can call the DND extension
PROCEDURE:
From SLT phone- Dial # 83
To Next Page
Loading...
