model no. 040-1192-0
KEY PARTS/LISTE DE PIECES
INSTRUCTIONS/INSTRUCTIONS
ASSEMBLY
1
C
Remove the safety clip (1) from the rack arm (C).
3
ASSEMBLY
J
H
K
J
I
G
1
Insert bolt (G) into the aligned holes and secure
using a flat washer (I), spring washer (H) and
nylon lock nut (K). Tighten
the nut using
3/4" (19 mm) wrench (not included).
5
6
Note: Use protective caps (J) to cover the bolt
head and nut.
Align holes at the
upper part of the centre mast (B)
with the corresponding holes on the
rack arm (C).
4
C
B
Replace the safety clip (1).
6
7
M
3
4
Fit one end of the cradle strap (M) onto all eight
cradles (3) of the rack arm
. Fit the remaining
four cradle straps to one side of each anti-sway
cage (4).
Note:
Ensure that the cradle strap is fitted on the
single peg side of the cradle.
7
This bike carrier can be fitted to vehicles
equipped with a 1 1/4" (3.2 cm) or 2" (5 cm)
hitch receiver.
• Follow steps 9 and 10 for fitting the bike
carrier to a 2" (5 cm) hitch receiver.
• Follow steps 11 to 13 for fitting the bike
carrier to a 1 1/4" (3.2 cm) hitch receiver.
KEY PARTS/LISTE DE PIECES
INSTRUCTIONS/INSTRUCTIONS
ASSEMBLY
Note:
Ensure the rack arms are in the opposite
direction of the stinger
.
8
To Next Page
Loading...
