5
Using your extractor
For best performance, you should switch on the extractor 15 minutes
before starting to cook and leave it to run for approximately 15
minutes after the end of cooking.
Control Panel
A – Light switch
B – Power indicator light
C – Power switch
To switch the extractor light on or o
• Slide the light switch to position A1 for o, or A2 for on.
To switch on the extractor, or change the motor speed
• Slide the power switch to the position required dependent on the
speed you require.
To switch the extractor o
• Slide the power switch to position C1 for o.
Fig. 1
C2 C4
A B C
A1 C1A2 C3
To Next Page
Loading...
