CDA FW422 User Manual

8
Installation
Installation into the furniture:
1. Carefully lift the refrigerator into the furniture aperture, taking care not
to damage the cabinet edges. The front edge of the feet should be in line
with the front edge of the cabinet.
2. Align the refrigerator so that the gasket sealing strip is close to the
non-hinge side of the unit and secure the refrigerator in position using
two screws, one through each foot.
3. Screw the top support bracket to the underside of the top shelf using
three screws (supplied)
4. Fit the slider brackets to the refrigerator door using two screws, as shown
in the image below:
5. Next, mark and fix into position the slider guides on the fascia door.
The sliders should be located 20 – 22mm from the edge of the door
as shown. Secure in position after fitting the sliders into the slider
brackets using two screws, taking care to ensure that the screws will not
pierce all the way through the fascia (heavily rebated doors). See fig 5.
fig. 4
fig. 5
20 mm
x2
x2

CDA FW422 Specifications

General

Door hinge	Right
Product color	White
Reversible doors	Yes
Shelves material	Tempered glass
Custom panel-ready	No
Appliance placement	Built-in
Fridge door balconies	3
Fridge number of shelves/baskets	6
Noise level	41 dB
Climate class	-
Fridge net capacity	134 L
Fridge gross capacity	135 L
Connected load	- W
Energy efficiency scale	A to G
Annual energy consumption	116 kWh

Weight and Dimensions

Depth	550 mm
Width	540 mm
Height	875 mm