9
Installation
Reversing the door (performed prior to install)
The door on this product can be easily reversed to suit any requirement. To
do this, proceed as follows:
1. Remove the top decorative cover caps on the non-hinge side and keep
for later use.
2. Whilst supporting the door, remove the upper hinge by undoing the two
fixing screws
3. Remove and rotate the door through 180° and relocate the bottom door
pin in the lower support.
4. Refit the top hinge on the opposite side, ensuring the screws are securely
tightened (Do not use power tools)
5. Fit the decorative cover caps in the non hinge side.
To Next Page
Loading...
