26
Inside of oven
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm
water. Suitable proprietary chemical
cleaners may be used after first consult-
ing with the manufacturers recommen-
dations and testing a small sample of the
oven cavity. Abrasive cleaning agents or
scouring pads/cloths should not be used
on the cavity surface.
NOTE: The manufacturers of this appli-
ance will accept no responsibility for
damage caused by chemical or abrasive
cleaning.
Let the oven cool down and pay spe-
cial attention no to touch the hot
heating elements inside the oven cav-
ity.
Assembling and remov-
ing the side racks
– Fit the side runner frames into the
holes on the side walls inside the oven
(Fig. 30).
– Slide the tray and rack into the runners
(Fig. 31).
The rack must be fitted so that the safe-
ty catch, which stops it sliding out,
faces the inside of the oven.
–To dismantle, operate in reverse order.
Fig. 30
Fig. 31
To Next Page
Loading...
Need help?
General
