6
DTC Orientation
Proper Use
o Have a solid balanced stance.
o Push torque wrench at center of handle.
o When torque wrench reaches audible click or buzz release torque wrench.
o Push torque wrench slowly and evenly.
CERTIFICATION
This DTC was calibrated at factory using torque calibration system that is traceable to National
Institute of Standards and Technology (N.I.S.T.). Testing parameters comply with ISO 6789:2003
and ASME B107:300-2010 (B107.29).
MAINTENANCE / SERVICE
Clean DTC by wiping with a damp cloth. DO NOT use solvents, thinners or carburetor cleaners.
DO NOT immerse in anything.
Service, repair and calibration are to be done by CDI Service Center only. Contact your
CDI Torque Products representative.
CALIBRATION
Contact your CDI sales representative for calibration services.
IMPORTANT! Calibration events are recorded in wrench memory which
provides evidence to void factory certification of compliance.
Clockwise Vertical Mounting
Counter Clockwise Vertical Mounting
Push torque wrench in this
direction for clockwise check
Push torque wrench in this
direction for counter
clockwise check