17CDL Sugaring Equipment
HOW TO REPLACE FILTRATION CARTRIDGES
1. Unscrew the cartridge housing.
2. Remove the old cartridge.
3. Insert the new cartridge into the housing.
4. Lubricate the transparent gasket lightly with silicone grease. Make sure the gasket is still
in place.
5. Make sure that the cartridge is centred in the housing. Screw the housing into place.
HOW TO INSTALL MEMBRANES
1. Unscrew the cover from the housing.
2. Remove the old membrane.
3. Lightly lubricate all O-rings and casing seals with silicone-based food-grade grease. Insert
the new membrane fully into the housing.
4. Make sure the membrane seal is on the cover side.
5. Screw the cover onto the housing.
1
1
2 3
3 4
4
2
5
5
To Next Page
Loading...