POWER SUPPLY
Do not power up the A22POE until all connections are completed.
The module operates from PoE+ sources using the DC output of the pre-assembled PoE+ splitter and provides
fully monitored power solutions using:
• Smart Battery Deep discharge prevention with automatic electronic cut-o.
• Programmable & Adaptive battery charging algorithm (250mA (default), 320mA, 500mA, or 1A).
• Intelligent battery monitoring & charging algorithms allowing optimum performance using standard
lead acid or gel cell type batteries.
• Real Time Monitoring algorithm for ‘Battery Low/Disconnect/Reversal’ and ‘Insucient Main Power’.
PoE+ Source
The PoE+ splitter to DC power supply is pre-installed in the A22POE box but needs to be connected to the PCB.
Simply plug the two pin terminal to the input power supply.
See “Recommended Wiring” section for more information on wiring type, size, and maximum length.
To Next Page
Loading...
