What to do if my CECOR SE15 Industrial Equipment will not start?
If your CECOR Industrial Equipment won't start, there are several things to check: * Ensure the unit is plugged into the proper voltage. * Check the electrical supply fuses or circuit breaker. * Inspect the vac motor brushes and replace them if needed.
Why is my CECOR SE15 Industrial Equipment losing suction?
If your CECOR Industrial Equipment is experiencing a loss of suction, consider the following: * Check the filter. If it's full, empty it. If it's blinded, clean it or switch to a coarser filter bag. * Inspect the hose for any blockages. * Examine the gauge and replace it if necessary. * Empty the tank if it's full. * Ensure the discharge valve is closed. * Check gaskets and loose connections for air leakage. * Reset the vacuum relief to 13" Hg or replace it.
What to do if my CECOR SE15 Industrial Equipment will not discharge?
If your CECOR Industrial Equipment won't discharge, try these steps: * Check the hose for any blockages. * Inspect the tank bottom for a buildup of fines and clean if necessary. * Ensure the cap is on the suction port. * Check gaskets and loose connections for air leakage.
What to do if fluid is coming out of the "Discharge" Tank-to-Pump connection in my CECOR SE15?
If you notice fluid coming out of the "Discharge" Tank-to-Pump connection on your CECOR Industrial Equipment: * Check the float control; clean or replace it if necessary. * Consult your coolant supplier. * Check to see if air is being sucked into the discharge due to tank turbulence.
General| Brand | CECOR |
|---|---|
| Model | SE15 Series |
| Category | Industrial Equipment |
| Language | English |
To Next Page