EasyManua.ls Logo

cecotec BONGO D40 XL CONNECTED - 7. ERROR CODES

cecotec BONGO D40 XL CONNECTED
164 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
68
ENGLISH
ORIGINAL MANUAL TRANSLATION
- Charge it only if the room temperature is between 0 °C and 35 °C and store it at a
temperature between -10 °C and 35 °C.
- Do not store the electric scooter outdoors. Store it in a safe and dry place. Cover it to
protect it from dust if necessary.
Battery release
To properly remove the battery for later recycling, you must remove the screws located on the
underside, on the side opposite the deck of the scooter.
7. ERROR CODES
If the electric scooter displays any of the following error codes, you should not attempt to
disassemble or repair the electric scooter yourself. Repairs carried out by unqualied persons
may result in injury or serious malfunctions. Please contact the place where you bought the
device or the ocial Cecotec Technical Support Service. The repair must be carried out by an
authorised technician, and you must use only original spare parts.
Error code Description
E0 Overheating protection
E1 Motor failure
E2 Motor phase failure
E3 Brake failure
E4 Accelerator failure
E5 Low voltage protection
E6 Communication failure between controller and the display
E7 Surge protection
E8 Motor start-up signal
E9 Motor block failure

Table of Contents

Related product manuals