cecotec Conga 7090 - Page 43

CONGA 5490 AI | 43
ENGLESK
to ensure ecient operation.
Dust tank
Fig. 28.
Take the dust tank out.
Open the dust tank cover and empty it.
Use the cleaning brush to clean the inside of the dust tank.
Install the dust tank back in the robot.
Wet&Dry tank
Fig. 29.
Take the Wet & dry tank out.
Detach the dust compartment from the rest of the tank.
Open dust compartment and empty it.
Use the cleaning brush to clean the dust compartment.
Assemble the dust compartment in the Wet & dry tank.
Install the Wet & dry tank back in the robot.
If the Scrubbing mode has been used, empty the water tank and then ll it
with clean water to rinse it. Empty it again before installing it back in the
robot.
High-eciency lter
Fig. 30.
Remove the high-eciency lter and shake it to remove all the dust.
Note:
Replace the high-eciency lter every 3 months depending on the frequen-
cy and type of use.
Clean the lter periodically with a brush to avoid blockage. Do not use water
or detergents.
Side brush
Fig. 31.
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to
replace the side brushes every 3 months, depending on the frequency and
type of use.
Free-fall sensors
Fig. 32.
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned o and in its original pack-
age.