cecotec Conga 7090 - Cleaning and Maintenance

42 | CONGA 7090 AI
ENGELSK
eas where you do not want the robot to clean. You can set more than 1 re-
stricted area at the same time on the map.
It can only be activated from the App.
Twice mode: Use this mode to carry out a deep, thorough cleaning of your
home. It can be combined with Edge, Spiral, Spot or Smart Area modes. The
robot will carry out 2 full cleaning cycles and then will return directly to the
charging base.
Final cleaning
Before returning to the charging base, the robot moves forward and back-
ward several times in order to eliminate any rests of dust from the brush.
6. Cleaning and maintenance
Main brush
Turn the robot around and press the main brush’s release button to take the
cover out.
Take the main brush out and clean the compartment.
Clean the main brush with the provided tools and use water and soap if
necessary.
Place the main brush in its position and fasten the cover’s clip.
Recommendation: Replace the main brush every 6-12 months to ensure ef-
cient operating (depending on the frequency and type of use).
Fig. 25.
Main brush cover
Tab
Main brush
Compartment
Silicone brush
Fig. 26.
To clean the silicone brush, follow the instructions on the previous section
to remove it from the robot and wash it with water and soap. Dry it thor-
oughly before assembling it back in order to ensure ecient operation.
Jalisco brush
Fig. 27.
To clean the Jalisco brush, follow the previous section’s steps to take it out
and clean it with water. Dry it thoroughly before assembling it back in order