cecotec Conga 7490 Eternal Genesis - Page 31

CONGA 7490 ETERNAL GENESIS CONGA 7490 ETERNAL GENESIS
6160
ENGLISH ENGLISH
Maximum power transmission: 20 dBm
Technical specications may change without prior notication to improve product quality
Made in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
8. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions, and deadlines established by the
applicable regulations. It is recommended that repairs be carried out by qualied personnel. 
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact the ocial Cecotec Technical Support Service at +34 963 210 728.
9. COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES,
S.L. All rights reserved. The contents of this publication may not, in whole or in part, be
reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic,
mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC
INNOVACIONES, S.L.
10. DECLARATION OF CONFORMITY
Cecotec Innovaciones hereby declares that this robot vacuum cleaner, model 08595 Conga
7490 Eternal Genesis is in conformity with the Radio Equipment Directive 2014/53/EU.
The full text of the EU Declaration of Conformity can be found on the following website:
www.cecotec.es
The robot vacuum cleaner did
not carry out the scheduled
cleaning task.
Check if the robot vacuum cleaner is in Sleep mode and
change mode. This option can be found on the general
settings of the robot vacuum cleaner and allows you to
dene time slots in which the robot will not perform the
scheduled cleaning tasks when in Sleep mode.
Make sure the robot vacuum cleaner is plugged to the
mains, that it will not be able to carry out scheduled
cleanings oine, and that the battery is not low.
The robot vacuum cleaner
does not return to the
charging base after spot
cleaning or after changing the
starting position.
The robot vacuum cleaner will map and calculate a
new route after running in Spot cleaning mode or after
changing its starting position.
If the charging base is very far away from the robot
vacuum cleaner, it will not be able to charge back
automatically. Manually move the robot vacuum cleaner
to the charging base.
The robot vacuum cleaner
does not resume cleaning.
Make sure the robot vacuum cleaner is not in Sleep
mode, as it will not resume cleaning in this mode.
It will not resume cleaning when it is manually placed on
the charging base.
The robot vacuum cleaner is
always oine.
Make sure the robot vacuum cleaner is successfully
connected to a 2.4 GHz network and always in areas
with good Wi-Fi signal.
The connection between the
smartphone and the robot
vacuum cleaner failed.
Make sure the robot vacuum cleaner and the charging
base are in an area with good Wi-Fi signal, reset the
router, and retry connection.
6. TECHNICAL SPECIFICATIONS
Model: Conga 7490 Eternal Genesis
Product reference: 08595
Voltage: 100-240 V ~ 50/60 Hz
Rechargeable Li-ion battery
Rated capacity: 14.4 V 2500 mAh
Typical capacity: 2600 mAh
Wi-Fi connection: Wi-Fi IEEE 802.11 b/g/n 2.4 GHz