CONGA ANIMAL
8
SAFETY INSTRUCTIONS
- Read these instructions thoroughly before using the
appliance. Keep this instruction manual for future reference
or new users.
- Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is grounded.
- This product can only be disassembled by qualied
personnel.
- Never touch the cord, the power socket or the adapters with
wet hands.
- Keep the robot away from clothing, curtains and any other
similar materials.
- Do not expose the robot to direct sunlight, open re or wet
environments.
- Do not sit or place heavy or sharp objects on top of the
appliance.
- This product is designed for indoor use only, do not use
outdoors.
- Before operating the robot, remove all objects and wires
that could affect its operating.
- Always place the device on a at and stable surface. Avoid
placing it on unstable surfaces where there is risk of falling,
like tables or chairs.
- Turn off the power switch, located on the lower part of the
robot, when it is not going to be used for a long time.
- Before operating it, make sure both the robot and charging
base connections are in good conditions.
- The robot cannot pass over obstacles higher than 15 mm.
- The service temperature life of the robot is between 0 and
40ºC. Avoid operating the product under extremely high or
low temperatures.
To Next Page
Loading...
