cecotec Conga Animal - 4. CLEANING AND MAINTENANCE; Component Cleaning; Battery Care

CONGA ANIMAL
49
ENGLISH
4. CLEANING AND MAINTENANCE
Side brushes
- Clean the side brushes when they are dirty, in case they are worn, replace them.
- After cleaning them, place them in their corresponding side. Every brush is marked with an
“L” or “R” to tell them apart.
Dust tank and lters
- Clean the water tank and lters after every use, as shown in Fig. 16.
WARNING:
- When removing the dust tank, make sure there are no obstacles or substances which
could block the robot vacuum channel.
- The efciency lter cannot be washed with water.
- After cleaning the primary lter with water, make sure it is completely dry before placing
it again on the robot.
Sensors and charge terminals
- Use a soft and dry cloth to clean the sensors and charge terminals.
Water tank
- Empty the water tank waste water after every use.
- Clean the water remains and let the tank dry on its own before storing it.
Mop
- Remove the mop bracket and gently pull the mop to detach it.
- Clean the mop and let it dry before storing it.
Battery
To lengthen its shelf life, follow these recommendations:
- Let the robot charge for 24 hours during the 3 rst charges.
- After nishing cleaning, the robot will return to the charging base. Make sure that the
charging base is plugged into a power supply.
- If the robot is not going to be used for a long period, completely charge the battery, turn off
the power switch, remove the battery and store it in a dry and ventillated place.
5. TROUBLESHOOTING
The robot will beep to indicate any error during operation. Different errors will emit a different
number of beeps.
Beeps and red ashing light: