cecotec CONGA ROCKSTAR - Parts and Components; Before Use; Product Assembly

CONGA ROCKSTAR 1200 ULTIMATE-ERGOFLEX | 21
ENGLESK
1. PARTS AND COMPONENTS
Fig. 1
1. Electric suction base release button
2. Vacuuming tube release button
3. Dust tank release button
4. High-eciency lter
5. Power push button
6. On/o button
7. Power supply
8. Battery
9. Power adapter
10. Vacuuming tube
11. Suction base
12. Narrow brush for furniture and corners
13. Wide brush for furniture and corners
14. Wall bracket
15. Wall plugs
16. Screws
17. Dust tank
18. Jalisco brush
19. Silicone and bristles brush
20. Adhesive for wall bracket
21. Water tank for scrubbing (Optional)
2. BEFORE USE
- Take the product out of the box.
- Check for any visible damage. If any is observed, contact as soon as
possible the Technical Support Service of Cecotec for advice or reparation.
3. PRODUCT ASSEMBLY
Vacuuming tube and suction base assembly
Fig. 2
- To install the suction base into the vacuuming tube, align both of them
making sure the tab on the suction base matches the guides on the tube,
and introduce one into the other until they are rmly xed. To disassemble
them, press the suction base release button and pull from the vacuuming
tube while you hold the suction base.