cecotec CONGA WET AND DRY - Filter and Deposit Cap Installation

ENGLISH
15
Conga Wet&Dry
5. Add water
Add water to water max. level (Fig. 7). Do not exceed the max level, or the water will spill out.
7
6. HEPA lter
Rotate the deposit cap anticlockwise to remove the lid.
Rotate the HEPA base anticlockwise in order to rimove the Hepa lter.
The HEPA lter must be cleaned regularly in order to keep a high suction power. Once removed
the lter, clean it with lukewarm water (no detergents). Once the lter is completely dry, rotate it
clockwise to set it. (Fig. 8)
8
7. Place the water deposit cap
Put the water deposit cap in the water deposit and rotate it clockwise to close (Fig. 9).
9
8. Safety clamp
Place the head unit and use the clips to lock the head by pushing them down (Fig. 10).