cecotec CREMMAET COMPACT STEAM - Troubleshooting; Troubleshooting Common Issues

CREMMAET COMPACT STEAMCREMMAET COMPACT STEAM
4746
ENGLISH ENGLISH
2. Pull the right panel outwards.
3. Press where the blue arrow in gure 15 indicates and remove the processing unit.
4. Lift the drip tray slightly and remove it.
Fig. 16
1. Replace the water tank in the coee machine.
2. Push the processing unit along the groove until a snapping noise is heard, as shown in
gure 16.
3. Push the drip tray inwards into place.
Warning:
- When reinstalling the processor unit, a snapping noise will be heard; if you do not hear it,
disassemble the processor unit again and reinsert it.
- Make sure that the water tank is fully inserted. If this is not the case, push the water tank
down until it clicks into place.
6. TROUBLESHOOTING
In the event of a fall or malfunction, unplug the appliance immediately from the mains socket.
If a mechanical failure occurs in the appliance, please contact your supplier, authorised dealer
for repair or the ocial Cecotec Service Centre.
Num Problem Num Possible cause Solution
1 The control
panel display
shows
the water
tank icon.
1.1 Water tank is out of
water.
Fill the water tank and install it in
the appliance.
2
The display
shows
“continuous
square line”,
press the
Settings/Exit
button but
the coee
machine
does not
dispense
water.
2.1 The water tank is not
correctly installed.
Install the tank securely inside
the coee machine.
2.2 No pasa agua por la
bomba.
Contact the ocial Cecotec
Technical Support Service.
2.3 The internal piping is
blocked.
Contact the ocial Cecotec
Technical Support Service.
Steamer
After frothing the milk, always
immerse the steamer in a cup
of clean water. Follow the
same milk frothing process to
clean the steamer. Then dry
the steamer with a cloth and
keep it clean.
Remove and rinse the steamer
periodically in case of daily
use.
You can use liquid or cleaning tablets to
remove milk residue.
Drip tray
and waste
container
Remove the drip tray and the
waste container, rinse them
under running water and wipe
them with a cloth.
Clean them at least every two
days.
Water tank
Rinse the tank under running
water every 3 days.
Empty it if you are not going to
use it for a long time.
Coee bean
container/
grinder
Clean the coee bean
container weekly. Use a soft,
dry cloth to wipe oil/coee
grounds from the inside.
If there is too much oil inside
the bean container, it is
possible that there is too much
oil in the grinder.
Clean the grinder thoroughly in
case of grinding problems.
To clean the bean container and the
grinder, you can use a grinder cleaner for
coee machines: place the cleaner inside
the container and prepare an espresso
with the maximum amount of coee.
Then, clean the container by hand.
Ground coee
groove
Open the right panel, remove
the brewing unit and clean the
ground coee channel with a
soft cloth on a weekly basis.
Dismantling parts for cleaning
Fig. 15
1. Pull the water tank upwards and remove it.