cecotec Total Iron 10100 Pro - Using the Garment Steamer; Autocleaning and Auto-off Features; Storage Instructions

26 | TOTAL IRON 10100 PRO
ENGELSK
Using the garment steamer
The garment steamer enables you to remove crea-
ses with only a few strokes. It is easy to use, safe for
all garments and a great solution for delicate fabrics
like silk.
- Switch on the garment steamer by pressing the
garment steamer power-on button on the panel.
- The on light indicator will turn on red when he-
ating, and then will turn blue to indicate that the
garment steamer is ready for use.
- Press the steam button to start steaming.
Autocleaning
Warning: The appliance cannot be used during the Autocleaning process, do
not interrupt it. Note: The Autocleaning process is automatically activated
after 2 litres of water have been used.
1. During the Autocleaning process, the cleaning light indicator on the pa-
nel will turn on red. This process will last approximately 3 minutes. The
device might emit some noises during the process due to the inner pro-
cess.
2. Afterapproximately3minutes,rinsingwaterwillowintothedirtywa-
ter tank.
3. Pull out the dirty water tank and empty it.
4. Slide the dirty water tank back into the appliance.
Auto-o
This appliance is equip-
ped with an automatic
shut-o function. When
the steam trigger is not
used for more than 15 mi-
nutes approx., the appli-
anceautomaticallyshutsoandswitchestothestandbymode.
Storage
1. Fold the ironing board and hanger bracket to the storage position.
2. Store the cord in its corresponding compartment.
3. Store the iron and garment steamer in their corresponding compart-
ment.
4. Move the appliance by pulling it along by the board handle.
Tip: After a long ironing session, it is advised to keep the ironing board fol-
ded out to let it dry before you store it.