Celestron C4.5 User Manual

Attaching the Accessory
Tray
Once the tripod is standing you are ready to attach the accessory tray. To do
this:
1. Locate the wing nuts used to hold the accessory tray to the bracket.
2. Locate the brackets that holds the accessory tray. The brackets will be
hanging down inside the tripod.
3. Hold one of the brackets up so that it is parallel to the ground.
4. Insert one of the screws on the bottom of the accessory tray through the
hole in the bracket. The screw should go through the top of the acces-
sory tray and protrude out the bottom.
5. Thread the wing nut onto the screw of the accessory tray to hold it in
place. Repeat this process for the other two brackets (see figure 2-3).
6. Pull the tripod legs apart as far as they can go. This will give youa
wider, more stable base.
7. Tighten the wing nuts that hold the accessory tray in place.
8. Tighten the wing nuts that hold the tripod legs to the mount for added
stability.
With the accessory tray in place, the tripod is much more stable, making it
easier to attach the telescope.
Bracket
Accessory
Tray
Tripod Leg —
Wing Nut
Figure 2-3
Assembling Your C45 *
7

Celestron C4.5 Specifications

General

Brand	Celestron
Model	C4.5
Category	Telescope
Language	English