2
• All supply lines and cables must not be subjected to additional loads and must be
laid in such a way that they are not damaged or crushed.
• Please position the screen so that there is no wind so that it cannot fall over. The
screen is approved for indoor use only.
• Failure to follow the above instructions may result in personal injury and damage
to the product or equipment connected to it. Incorrect installation or use may also
invalidate the warranty.
• If you are unsure about the use of the product, please contact your specia-
list personnel, your dealer or celexon directly (Web: www.celexon.co.uk, Mail:
info@celexon.co.uk).
• Technical changes and errors excepted.
The manufacturer accepts no responsibility for damage to property or personal injury,
if the screen is used outside the recommended specications, or improper installation.
Do not use this screen near heaters or air conditioners. Do not install or use the pro-
duct in direct sunlight or in front of a window. Due to the temperature-sensitive PVC
surface, this may cause permanent damage to the projection screen surface.
We recommend that you wait approx. 2 hours after delivery before installing the
screen.
This allows the screen to acclimatise. Wait approx. 24 hours if the screen is moved
from a particularly cold to a warm environment (or vice versa).
Please avoid any stains on the surface of the screen. It may not be possible to remove
these.
The positions of the end points on the motor are already set at the factory and may
only be changed minimally (see page 15).
DISCLAIMER
The information in this document is subject to change without prior notice by
the manufacturer. Changes will be added in subsequent versions of this ma-
nual. Errors excepted.
To Next Page
Loading...
