EasyManua.ls Logo

celios G200 - Troubleshooting

Default Icon
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
33
Troubleshooting
Problem Possible Cause Solution
Unit does not power on
• Battery(ies) or AC adapter not installed
• Battery(ies) installed do not have charge
• Install charged Batteries or connect
to AC adapter
• Replace Batteries with charged ones
or install AC adapter
Battery should be charging
• Battery(ies) is(are) full
• No battery(ies) inserted
• AC adapter not plugged in
• Battery may be at end of life
• Battery may be over temperature limit
• The battery light will not display when
full and attached to AC adapter
• Insert 1 or 2 batteries into either slot
• Plug AC adapter into a working outlet
• Install new Battery and recycle old
• Allow the Battery(ies) to cool before
use
Pressure Light AND Warning Light
are illuminated AND Beeping is
heard
• Core Filter not installed properly
• Core Filter is loaded
• Ensure the Core Filter is fully seated
and latched into the Core
• Remove and discard old Core Filter;
install new Core Filter
Unit powered on AND Fan does not
operate AND Warning Light ashing
• General system error (Warning, Pressure,
Beep)
• Remove all power sources; install
AC adapter to verify operation; add
Battery(ies)
Problem Possible Cause Solution
Remote will not pair
• Error in communications • Remove batteries in Remote;
Pressure Light AND Warning Light
are illuminated AND Beeping is heard
remove all power sources from the
Core; reinstall power to the Core then
batteries into the Remote; perform
pairing sequence again
Flow is reduced but no Pressure
Warning Light
• Core Filter life is very close to zero • Replace the Core Filter
Air exiting the Core has an
unpleasant smell
• Carbon Filter may be depleted • Replace the Carbon Filter
Core will not t into the Main Stand
• Pre Filter may not be seated fully • Press the Pre Filter fully into place
and install the Back Cover
Unit powers on then immediately
powers off
• Battery(ies) may be low • Charge Battery(ies) with the supplied
AC adapter
Filter Life Button ashing AND
Beeping
• Filter Life trip point has been met • Press the Filter Life Button once to
silence; Filter Life Button will be solid
but no Beep

Other manuals for celios G200