48
07 Maintenance
10. Repeat steps 7 to 8 with air instead of water/ethanol to dry the microvalve.
11. Disconnect the microvalve and let it air dry.
12. Connect the nozzle to the provided tube. Use the syringe to ush with water or ethanol, then water. Hold the nozzle ghtly when ushing to
prevent it from disconnecng from the tube (Figure 27).
13. When the parts have dried, reassemble the printhead for storage (Secon 4.2).
Figure 27: Connecng the nozzle for cleaning.
To Next Page
Loading...
