Cello Electronics Traveller - Page 20

2. Press ◄/► button to adjust or press ▲/▼ button to select. And press ENTER button to select the sub menu.
Press
▲/▼ button to select Picture Mode, then press ENTER button to enter and press ▲/▼ button to select.
(Available Picture Mode: User, Dynamic, Standard, Mild)
You only can change the value of brightness, contrast, sharpness, color, when the picture is in User mode.
TIPS: You can press P-MODE button on the remoter control again and again to change the picture mode directly.
3. After finishing your adjustment, press
MENU button to save and return back to the previous menu, and press
EXIT button to exit the entire menu.
Picture Mode
Press
▲/▼ button to select Brightness, then press ENTER button to enter and press ◄/► button to adjust. Then
press MENU button to return back the previous menu directly.
Brightness
Press
▲/▼ button to select Contrast, then press ENTER button to enter and press ◄/► button to adjust. Then
press MENU button to return back the previous menu directly.
Contrast
Press
▲/▼ button to select Sharpness, then press ENTER button to enter and press ◄/► button to adjust. Then
press MENU button to return back the previous menu directly.
Sharpness
Press
▲/▼ button to select Colour, then press ENTER button to enter and press ◄/► button to adjust. Then press
MENU button to return back the previous menu directly.
Colour
Press
▲/▼ button to select Tint, then press ENTER button to enter and press ◄/► button to adjust. Then press
MENU button to return back the previous menu directly.
Tint
Press
▲/▼ button to select Colour Temperature, then press ENTER button to enter and ◄/► button to select
Standard, Cool, Warm.
Colour Temperature
Press
▲/▼ button to select Aspect Ratio, then press ENTER button to enter and ◄/► button to select Auto,4:3,
16:9,Full,Zoom1,Zoom2,Cinema,Just Scan.
Aspect Ratio
Press
▲/▼ button to select Noise Reduction, then press ENTER button to enter and ◄/► button to select Off,Low,
Middle,High.
Noise Reduction