27
• Enter the 6 digit master code, press the program button followed by enter. The
program button will light up, showing that the E12 is ready to be programmed.
• To program wireless zones, press the Stay button, followed by 2
nd
function
followed by enter. The Stay and Prog button will light up and all the active
wireless zones will light up. If no zone buttons light up, no wireless zones are
active in Away Mode.
• To program a wireless zone to be active in Stay Mode, press the corresponding
zone number button on the keypad. The button will light up, indicating that the
zone will be active in Stay Mode.
• To deactivate a zone, press the corresponding zone number button on the
keypad. The button light will switch off, indicating that the zone will not be active
in Stay Mode.
• When all the zones have been programmed, simply press enter to return to
program mode.
3.7.3. Programming active zones for Monitor Mode
Wired Zones:
• Switch the E12 to Off Mode.
• Enter the 6 digit master code, press the program button followed by enter. The
program button will light up, showing that the E12 is ready to be programmed.
• To program wired zones, press the Monitor button, followed by enter. The
Monitor button will light up and all the active zones will light up. If no zone buttons
light up, no wired zones are active in Monitor Mode.
• To program a wired zone to be active in Monitor Mode, press the corresponding
zone number button on the keypad. The button will light up, indicating that the
zone will be active in Monitor Mode.
• To deactivate a zone, press the corresponding zone number button on the
keypad. The button light will switch off, indicating that the zone will not be active
in Monitor Mode.
• When all the zones have been programmed, simply press enter to return to
program mode.
Wireless zones:
• Switch the E12 to Off Mode.
• Enter the 6 digit master code, press the program button followed by enter. The
program button will light up, showing that the E12 is ready to be programmed.
• To program wireless zones, press the Monitor button, followed by 2
nd
function
followed by enter. The Monitor and Prog button will light up and all the active
wireless zones will light up. If no zone buttons light up, no wireless zones are
active in Monitor Mode.
• To program a wireless zone to be active in Monitor Mode, press the
corresponding zone number button on the keypad. The button will light up,
indicating that the zone will be active in Monitor Mode.
• To deactivate a zone, press the corresponding zone number button on the
keypad. The button light will switch off, indicating that the zone will not be active
in Monitor Mode.
To Next Page
Loading...