Coating Thickness Tester User Manual
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Shielded cables must be used with this unit to ensure compliance
with the Class B FCC limits.
The device must not be co-located or operating in conjunction with
any other antenna or transmitter.
Rev.181112
To Previous Page
Loading...
Need help?
General
