CEM DT-157 User Manual

9
Coating Thickness Tester User Manual
2-3-1-2. select measure mode (Probe)
The probe can work in three modes:
AUTO: The probe can automatically select the working mode. When
placed on steel (magnetic substrates), it will work in magnetic induction
principle. When placed on no-ferrous metals, it will work in eddy
current principle.
Fe: The probe works in magnetic induction principle.
No-Fe: The probe works in eddy current principle.
• Press left button to enter the menu
• Press Up/down button to select working mode
• Press left button to enter working mode
• Press up/down button to select working mode
• Press left button for OK.
3. Settings
3-1. Unit Setting
3-1-1. Select unit
• Press left button to enter the menu
• Press up/down button to select the setting
• Press left button to enter the setting
• Press up/down button to select Unit
• Press left button to enter
• Press up/down button to select
• Press left button for ok
3-2. Backlight Setting
Adjust the brightness of the backlight.
• Press left button to enter the menu
• Press up/down button to select the setting
• Press left button to enter the setting
• Press up/down button to select backlight
• Press left button to enter
• Press up/down button to adjust the brightness of the backlight
• Press right button to return.

CEM DT-157 Specifications

General

Brand	CEM
Model	DT-157
Category	Test Equipment
Language	English