EasyManua.ls Logo

Centek CT-1901 - Page 46

Centek CT-1901
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
45
ERROR INDICATION
Indicator
Probable cause Probable remedy
Pre-Wash Additional Rinse No Drying Start/Pause
Washing machine door is not firmly closed Check washing machine door
Water supply problem during washing
Check water supply tap
Check water pressure
Check filter
Drain routed too high
Drain tube frozen up
Drain tube blocked
Drain opening in the machine blocked
Place the drain tube lower
Use hot water or increase room temperature to thaw
off the tubes
Clean out the drain tube
Clean out the drain opening in the machine
Water overfill Check drain hose
ATTENTION
If the problem persists after the washing cycle is restarted, drain the water and contact an
authorized service center.
9. SPECIFICAIONS
Model
СТ-1901,
СТ-1902
СТ-1903,
СТ-1904
Electrical Safety Class I
Nominal voltage 220-240 V ~ 50 Hz
Power consumption, W 2000 2050
Nominal current draw, A 10
Maximum laundry batch weight, kg 6 7
Maximum drying speed, rpm 1000 1200
Energy Efficiency Class А+ А++
Drying Efficiency Class С
Power consumption per washing cycle, kWh 0,737 0,690
Power consumption per year, kWh 196 153
Water consumption per washing cycle, l 43 45
Total water consumption per year, l 9240
Drum capacity, l 39,5 45
Noise level during washing, dB 64
Noise level during drying, dB 79 77
Required water supply pressure 0,05 - 1 MPa
Water resistance class IPX4
Net weight, kg 52 55
Dimensions (WхDхH), cm 59,5х40х85
Dimensions with protruding parts (WхDхH), cm 67x57,3x88,8
10. DISPOSAL
Upon expiry of its service life the appliance can be disposed of separately from ordinary
domestic waste. You can turn it over to a specialized electric and electronic appliance disposal
and recycling centre.
11. CERTIFICATION DATA, GUARANTEE
The service life of this item is 10 years since the date of sale to the end user, provided the
item will be used in strict accordance with the present manual and the applicable technical
standards. Upon expiry of the service life please contact the nearest authorized service
centre for suggestions as to further operation of the appliance. The manufacturing date of the
appliance is integrated into the serial number (digits 2 and 3 - year, digits 4 and 5 - month
of manufacture). If any questions related to appliance maintenance should arise, or if the
appliance has malfunctions, apply to the CENTEK TM Authorized Service Center. The address
of the service center can be found on the website https://centek.ru/servis. Service support
contacts: Phone: +7 (988) 24-00-178, VK: vk.com/centek_krd. General Service Center: OOO
«Larina-Servis», Krasnodar, Phone: +7 (861) 991-05-42.
The product has the Certificate of Conformity.
12. MANUFACTURER AND IMPORTER INFORMATION
Imported to EAEU by: OOO «Larina-Elektroniks». Address: Russia, 350080 Krasnodar, ul.
Demusa, 14. Phone: +7 (861) 2-600-900.
DEAR VALUED CONSUMER!
The guarantee period for all appliances amounts to 24 months since the date of sale to the
end consumer. With this Warranty Card the Manufacturer confirms the proper condition of the
appliance and undertakes to repair, free of charge, all defects caused by the
Manufacturer’s default.
GUARANTEE MAINTENANCE TERMS
1. The guarantee shall be valid if the following documentation conditions are observed:
The original Warranty Card shall be filled out correctly and clearly, indicating the of
appliance model, serial number and sale date, the stamp of the seller company and
signature of its representative shall be available, as well as the stamps on each coupon
and the buyer’s signature in the Warranty Card.
The Manufacturer reserves the right to reject guarantee maintenance if the buyer fails
to provide the abovementioned documents or if the information contained therein is
incomplete, illegible or ambiguous.
2. The guarantee shall be valid if the following operation conditions are observed:
the appliance is used in strict accordance with the present manual;
the safety rules and requirements are observed.
3. The guarantee does not apply to regular maintenance, cleaning, installation and setup of
the appliance at the owner’s location.
4. The guarantee does not apply in the following cases:
mechanical damage;
normal wear of the appliance;
non-observance of operation requirements or erroneous actions on the part of the user;
improper installation or transportation;
natural disasters (lightning, fire, flood, etc.), as well as any other causes beyond the
Manufacturer’s or Seller’s control;
ingress of foreign objects, liquids or insects into the inside of the appliance;
repairs or modifications to the appliance by unauthorized persons;
use of the appliance for commercial purposes (loads exceeding normal domestic
application), connection of the appliance to utility and telecommunication networks
incompliant with national technical standards;
failure of the following accessories, if replacement of these is allowed by design and does
not involve disassembly of the appliance:
a) remote control units, rechargeable batteries, replaceable batteries (power cells),
external power supply units and chargers;
b) consumables and accessories (packaging, covers, slings, carry bags, mesh screens,
blades, flasks, plates, supports, grilles, spits, hoses, tubes, brushes, nozzles, dust
collectors, filters, smell absorbers);
for battery-powered appliances – operation with inappropriate or depleted batteries;
for rechargeable battery-powered appliances any damage caused by improper battery
charging and recharging.
5. The present guarantee is provided by the Manufacturer in addition to the consumer rights
determined by the applicable legislation and does not limit these rights in any way.
6. The Manufacturer shall not be made liable for possible damage, directly or indirectly
inflicted by CENTEK brand products on people, domestic animals, the consumer’s or third
persons’ property if such damage is inflicted as the result of non-observance of appliance
installation and operation requirements, deliberate or negligent actions (omission) by the
consumer or third persons, as well as of force majeure circumstances.
7. Service centers will only accept appliances in a clean state (there should be no food
residues, dust and other contamination on the appliance).
The Manufacturer reserves the right to change the design and specifications of the appliance
without prior notice.

Related product manuals