Center 210 - Safety Information; Environmental Conditions; Explanation of Symbols

1
I. Safety Information – Read first
• Read the user manual before use and follow all safety information.
• Use the meter only as specified in this user manual. Otherwise
meter protection may be impaired.
• Never use this meter on a circuit with voltages greater than
750Vrms @ 50/60 Hz.
• Do not operate the meter if the body or tests leads look damaged.
• Check the function selector range switch and make sure it is at the
correct position before each measurement.
• Do not perform resistance and continuity test on a live circuit.
• Exercise extreme caution when measuring live systems with
voltage greater than 60V DC or 30V AC.
• Use extreme care when working around bus bars and bare
conductors.
• Do not use the meter in over range/overload conditions (OL).
• Change the battery when the symbol appears to avoid
erroneous readings.
Environmental Conditions:
Altitude up to 2000 meters.
Operating temperature:
0°C ~ 40°C, <80% RH, non-condensing
Storage temperature: - 10°C ~ 60°C, <70% RH, battery removed
Pollution Degree: 2
Installation Categories III (600V), II (1000V)
Explanation of Symbols:
Attention! Refer to operation Instructions.
Dangerous voltage may be present at terminals.
This instrument has double insulation.
When servicing, use only specified replacement parts.
Approvals: EN61010 600V CAT III 1000V CAT II