1
II. Specification
General Specification:
Digital Display:
3 3/4 digits LCD display with maximum reading 3999
Analog Display:
Fast 42 segment analog bar graph display
Symbol and Scale range:
Automatic display according symbols and range input signal
Polarity:
Displayed when negative signal applied to the input
Over Load:
is Displayed when input signal exceeds measuring limit in 40A,
resistance and continuity range.
In voltage, current and frequency range, this symbol will not be
shown even the read reach the measuring limit. The measuring
limit of these ranges are :
ACV : 750V
DCV : 1000V
ACA : 1000A
Hz
: 10KHz
Sample Rate: 2 times/sec for digital data; 20 times/sec for analog bar
Low Battery Indication:
displayed when the battery is below the required voltage
Power Source: 9V, NEDA1604 or 6F22 or 006P
Battery Life: 180 hrs typical (Alkaline)
Auto Power Off:
The meter will power itself OFF if there is no push button or rotary
switch operation for 30 minutes.
To deactivate this function, press the “MAX MIN” button and keep it
pressed down, then power up the probe.
Clamp opening size: 40mm
Dimension (L x W x H) : 242 x 66 x 36 mm, 9.53 x 2.60 x1.42 inch
Weight: 400g, 14.10
OZ (battery included)
Accessory:
Instruction Manual, Carrying Case, Test lead, 9V Battery
To Next Page
Loading...
