Pg. 3580231-EN-V2025-02-14
Always unplug the treadmill from the electrical outlet before cleaning, lubricating or repairing the unit.
ERROR CODE
E17 - Lift Motor Calibration Error 1. Check that the incline adjustment motor cable is properly
connected.
2. Re-calibrate the incline motor.
E21 - Motor Control Board Save
Data Exception
1. Turn off the power using the On/Off switch.
2. After 3 minutes, turn the power ON. If the motor control board fails
to start, replace the motor control board.
E22 - Communication Error
Between Console and Motor
Control Board
1. Check that the cable between the console board and motor control
board is properly connected.
2. Check if the console or motor control board is damaged.
3. Turn off the power using the On/Off switch.
4. After 2 minutes, turn the power ON.
E30 - Motor calibration error 1. Replace the motor control board.
E31 - Overtemperature Wait until the machine temperature is normal before continuing to use.
E32 - Motor Reversal
E33 - Issue with Motor or Motor
Control Board
1. Replace the motor.
2. Replace the motor control board.
E40 - The Safety Key Not In
Place
1. Check if the Safety Key is loose or removed.
2. Check that the Safety Key moves free into place.
3. Check if the Safety Key is damaged.
4. Check if the console is damaged.
E50 - Other Error Please contact customer service.
Connection Error -
Communication error between
the Console and Console
Board
1. Check if the console board wire is loose or detached from the
console board.
2. Check the connectors of the console board and the console board
wire.
3. Check if the console is damaged.
4. Turn off the power using the On/Off switch. After 2 minutes, turn the
power ON.
To Next Page