Pg. 34 80231-EN-V2025 -02-14
console keypad will display one of the Error Codes in the following table.
Always unplug the treadmill from the electrical outlet before cleaning, lubricating or repairing the unit.
ERROR CODE
E00 - No Error Reset the power using the On/Off switch
E01 - Motor Overload 1. Motor current exceeds load rating. To prevent damaging the motor,
the system will restart.
2. A part of the treadmill is stuck, causing a the motor to shut off.
Check for parts that are not moving normally and also trying adding
running belt lubrication.
3. If you smell burning when the motor runs, or an unusual motor
sound, the motor may need replacement.
4. The motor control board may need replacement.
1. Check that the motor cable is properly connected.
2. Replace the motor or motor control board.
E03 - Motor Control Board
Overcurrent
1. Motor current exceeds load rating. To prevent damaging the motor,
the system will restart.
2. Check that the power cord and motor connection are properly
connected.
3. Replace the motor control board.
E04 - Phase Loss 1. Check that the motor cable is properly connected.
2. Replace the motor.
3. Replace the motor control board.
E05 - Undervoltage 1. Check that the input power supply voltage is normal.
2. Check if the power cord is loose.
E06 - Overvoltage 1. Check that the input power supply voltage is normal.
E7 - Incline Adjustment Error 1. Check that the incline adjustment motor cable is properly
connected.
2. Reset the power using the On/Off switch.
3. Re-calibrate the incline motor.
E08 - Motor Control Board
Error
1. Check that the power cord and motor connection are properly
connected.
2. Replace the motor control board.
E16 - Incline Adjustment Error 1. Check that the incline adjustment motor cable is properly
connected.
2. Reset the power using the On/Off switch.
3. Contact customer service.
To Next Page